0-0927827-2 927827-2 Connector Terminal Automotive Electronics Wire Connector

Some models of the luggage rear luggage in the battery, because the current is transmitted to the engine compartment electrical box and the starter, there will be a large line guide line that runs through the whole car. In traditional wiring, this large current wire is not different from other signal cables in the same line, which will inevitably interfere with the signal line. The distance distance (more than 100mm). At the same time, the sheet metal is required to make a groove to laid the wires, and it can be used to have an electromagnetic shielding effect.

2 to ensure the maintenance of the wire beam, the wiring beam can be well -maintained

When the vehicle electrical line is arranged, it should pay attention to its maintenance/maintenance. Once the electrical problem occurs, if you need to disassemble other parts of the parts, it will cause some unnecessary waste to increase the cost and time of maintenance. Good maintenance is reflected in the failure of electrical system failure, eliminating the fault in the shortest time, and avoiding damage to other components when the maintenance operation is avoided when the failure is eliminated.

The maintenance of the wire beam focuses on the areas that often need to be maintained:

The convenience of replacement of fuses and relays, pay special attention to parts that need to be disassembled to replace fuses and relays. Whether fuses and relays in each position can be pulled out normally.

The diagnostic interface position is easy to operate and maintained, the external equipment can be inserted normally, and the diagnostic interface itself can be disassembled

Maintenance of the electrical device that is easy

Use the maintenance of electrical appliances with high frequency, such as the entire car switch, multimedia, combined instrument, etc.

3 Guarantee the reliability of the line beam, the reliability assurance of the designing design

After ensuring the assembly and maintenance of the wiring beam, the reliability of the line bundle design should be focused on. In the three -dimensional layout of the online beam, the guarantee of the reliability of the line beam is mainly considering from the following methods:

Note: The following specific requirements are only the accumulation of personal work experience, but the recommended value. In the actual work process, the specific situation should be analyzed.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.