12 Pin 6098-6985 Car Door Lock Wiring Harness Brown Male Connector

Due to the complexity and diversity of wire beams, there are two options for wire beam manufacturers:

Either divide the wiring into smaller modules (if possible), manufacture on the dedicated assembly line of each module, and then perform the final assembly of the wiring later (at the same production place or near the auto manufacturer);

Or make final wiring on larger and more complicated assembly lines. But regardless of their choices, the manufacturing and final assembly of modules require the same manufacturing and assembly technology.

The production process is organized according to the assembly technology implemented, which is usually divided into:

Dynamic assembly line: It is usually used to make wiring beam modules and smaller wiring beams. Several types of dynamic assembly lines have been developed, but the most commonly used to create less complicated wire beams are composed of fixed assembly boards (tray). The transfer belt is located in the lower part of the wire, which is used to carry the carrier beam from one work section to another. The organizational method of the production line is provided on the front to ensure that the segment is in line with ergonomics.

The turntable (also known as the turntable) for large module manufacturing and module final assembly. The turning table consists of several boards installed on the track, so it can rotate. This production technology is usually used to decompose all tasks into several basic tasks. The assembly line consists of several boards. Each operator performs limited number of operations assigned to him before the rotation/mobile turntable. These operations are always the same. Establishing the production line speed can ensure productivity and quality standards.

Regardless of whether the manufacturer chooses to use a dynamic assembly line (LAD) or the turntable assembly line to assemble the wiring. In order to provide it, it is necessary to produce sections and equipment to produce as pre -assembly elements part of the final wiring.

The automation assembly process is a challenge for wire beam manufacturers. The automated wire beam assembly system must be very flexible and easy to adapt to meet the diverse and dynamic requirements of the project at all stages.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.